Yener Ticaret

Corrosion protection in steel structures: primer, intermediate coat and topcoat system

12 November 2026 · 2 min read

Corrosion protection in steel structures: primer, intermediate coat and topcoat system
In shortPermanent corrosion protection on steel surfaces is not achieved with a single coat of paint; it is provided by a system comprising surface preparation, a primer, an intermediate coat and a top coat. The system is selected according to the corrosion class of the environment and the expected service life.

What causes corrosion?

Steel rusts when it comes into contact with factors such as moisture, oxygen and salt. This process is much faster at coastal facilities and in industrial areas. A paint system forms a barrier that isolates the steel from these factors; some primers also provide active protection.

1. Surface preparation: the foundation of the system

Even the best paint will deteriorate prematurely on a poorly prepared surface. Where possible, rust, scale and old paint should be removed by sandblasting; for maintenance work where sandblasting is not feasible, products suitable for mechanically cleaned surfaces should be used. The surface must be dry and free from oil and salt.

2. Primer: adhesion and corrosion prevention

The primer is the first coat that adheres directly to the steel and prevents corrosion. Epoxy primers offer good adhesion and chemical resistance. Examples:

3. Intermediate coat: thickness and barrier

The intermediate coat increases the system’s total film thickness, thereby hindering the passage of moisture and oxygen. In high-corrosion classes, the thickness of the intermediate coat directly determines the system’s service life. High-solids epoxies are used for this purpose.

4. Top coat: appearance and UV resistance

Epoxies chalk over time when exposed to sunlight; for this reason, polyurethane or acrylic products are preferred as the top coat in outdoor applications. Hardtop AX and Hardtop XP are examples of polyurethane top coats with high colour and gloss retention.

Example system approach

Environment Approach
Indoors, low humidity An alkyd or single-coat epoxy system may be sufficient.
Industrial area, outdoor environment Epoxy primer + epoxy intermediate coat + polyurethane top coat.
Coastal area, high corrosion Epoxy system with a higher total thickness + polyurethane top coat; sandblasting where possible.

The examples in the table are a general guide. Coat thicknesses and products must be determined in accordance with the project specifications and the products’ current technical data sheets.

Common mistakes

  • Failure to observe inter-coat curing times
  • Adjusting the mixing ratio by eye for two-component products
  • Using the wrong thinner
  • Handing over the work without measuring the dry film thickness

If you would like a system recommendation for your project, please provide us with details of the surface, environment and square metres.

FAQ

If sandblasting is not possible, which product should be used?
Surface-tolerant epoxy sealants (e.g. the Jotamastic range) that can be applied following mechanical cleaning have been developed for this purpose.
Can epoxy paint be used as a top coat outdoors?
Epoxies tend to chalk in sunlight. A polyurethane or acrylic topcoat is recommended for exterior surfaces where appearance is important.

Let’s choose the right product together

Tell us about the surface, environment and conditions of use – we will send the right paint system, its data sheet and a quote the same day.